Opening Your Pool: the Chemical Order That Actually Works
Open in this order: get the debris out and the filter running first, then test everything, then balance in sequence — total alkalinity, pH, CYA — and add chlorine last, shocking only after the basics are in range. Most "my pool turned green a week after opening" stories come from shocking filthy, unbalanced water and hoping for the best.
Every spring the same thing happens: the cover comes off, the water looks like a pond, and somebody dumps in five bags of shock on day one. A week later the pool is green again and they are angry at the shock. The shock was fine. The order was wrong.
Opening is a sequence, not a shopping list. Get the order right and the chemicals are almost boring. Get it wrong and you will spend May fighting water that should have been settled in April.

Before any chemical: the physical opening
Pump the standing water off the cover before you drag it — that swamp juice does not belong in your pool. Scoop the big debris, brush the walls toward the drain, and get the filter running before you test a single thing. You cannot balance water you cannot circulate.
Top up the water to mid-skimmer, reinstall the plugs and baskets, and let the system run a few hours. Then, and only then, take your first full test: FC, pH, TA, CYA, and calcium. Write the numbers down. Opening blind is how people double-dose.
The chemical order: TA, pH, CYA, then chlorine
Balance in the order the chemistry wants, not the order the bottles are stacked in your shed. Total alkalinity first (80–120 ppm) — it buffers everything else. Then pH (7.2–7.8). Then CYA (30–50 ppm) — and go easy here, because overshooting stabilizer at opening means fighting it all summer with no way to remove it except draining.
Chlorine comes last because its target depends on everything above. Dose to your CYA level with the dose calculator, not to a number you remember from last year. Last year’s CYA is gone; test fresh.

Shocking at opening: yes, but after the basics
An opening shock is usually warranted — the water sat for months collecting organics. But shock into balanced water, not into a swamp. Get TA and pH in range first, then bring chlorine to shock level for your CYA and hold it there, testing daily until the water is clear and overnight loss is minimal.
If the pool opened genuinely green rather than just dull, skip straight to the full SLAM process — opening a green pool IS a SLAM, just with a cover involved.

The first-week plan
Run the filter 24/7 for the first few days — this is the week your filter earns its keep. Test daily: chlorine and pH at minimum. Brush everything, including behind the ladder and inside the skimmer throat, where winter biofilm hides.
Once the water is clear, chlorine is holding overnight, and all numbers sit in their target ranges, drop back to your normal weekly routine. A clean opening pays for itself all summer: every algae fight you skip in May is a weekend you get back in July. A preventive dose of algaecide once the water is stable is cheap insurance while the system settles in.
